"L" Design Torch Marver that fits the following Nortel torches.
Midrange, Midrange Plus, Major, Major Plus, Red Max and Red Max Plus
Bottom graphite is 51 x 76 x 16mm (2" x 3" x 5/8" thick). The front lip 10mm (3/8") wide and the rear graphite is 44 x 76 x 16mm (1-3/4" x 3" x 5/8")
The rear graphite is slotted to fit over the rear stainless lip, and is held by two (2) set screws using the same allen wrench. Over tightening can result in broken and/or cracked graphite which we WILL NOT be responsible for.
Using the supplied allen wrench, remove the two (2) front cap bolts from the burner side panel and store in a safe place for future use. Install the torch marver using the allen wrench and the two (2) new supplied cap bolts. Snug, but do not over tighten.
Torch NOT included.